HIGHEST PULL-OUT STRENGTH
50 % higher pull-out strength than conventional concrete protection slabs
RESISTANT TO WATER BACKPRESSURE
Water backpressures of up to 1.75 bar
are permanently withstood
VERY HIGH NUMBER OF ANCHOR STUDS
420 anchor studs per m² are an integral part of the liner
FOREVER SEALED SURFACES
>2200 N/stud shear resistance and 82 t/m² pull-out resistance for maximum safety
WIDE RANGE OF PRODUCTS
Available in PE/PP in widths between 1500 mm and 5000 mm
AGRU-Ultra Grip – for handling groundwater pressure
AGRU-Ultra Grip‘s patented conical stud design ensures the ultimate grip in concrete. By means of the newly developed AGRU-Ultra Grip concrete protection liner, groundwater pressures of up to 1.75 bar (at 20 °C) can now be permanently withstood. In large buildings, installation is even faster and cheaper, because by using the sheets of 5 m in width, which are also available from AGRU, you can save up to 60% of the welds that would normally be necessary. For an extra-long service life, AGRU-Ultra Grip also offers increased abrasion resistance.
AGRU-Ultra Grip with a signal layer
- Light signal layer so damage can be detected visually
- Improved installation due to the white, reflective layer for optimal flatness on the formwork
AGRU-Ultra Grip – use in tunnels
In the case of large underground structures such as sewage tunnels and collectors, service life span is of utmost importance. AGRU-Ultra Grip is a widely proven solution here. Optimised installation techniques in conjunction with the large-format sheets of up to 5 m in width offered by AGRU enable corrosion-resistant and leakproof linings to be installed rapidly and for a reasonable cost. Channels of this type are built with an internal diameter of up to 6 m and have a single- or double-layer design.
AGRU-Ultra Grip - Combisegements
The Combisegments offered by Herrenknecht Formwork are ready-to-use segments equipped with a circumferential seal featuring AGRU-Ultra Grip. The tunnel is lined with singlelayer segment rings by the tunnel boring machine in a single pass and – thanks to this new technology – permanently sealed. This completely removes the need for two work steps, namely the retroactive installation of a concrete protection liner and the welding work in the tunnel. Time and cost savings are the result. The image on the right shows segment formwork with an inserted Combisegments lining.
Completely safe welds
AGRU-Ultra Grip sheets are joined using extrusion welding or hot-gas wire welding to create completely leakproof joints. Even cracks that occur in the concrete later on are bridged safely and permanently.
High media resistance
AGRU-Ultra Grip made of polypropylene has become indispensable in surface technology. Electrolytic pickling and high temperatures can damage unsealed concrete pools and basins. AGRU-Ultra Grip is resistant to media and prolongs the life of concrete pools and basins.
The best material for every application.
Special colours are available on request.
+43 (0) 7258 790-3304
+43 (0) 7258 790-3313
Forward to the Product Catalogue